Remove the tool and reconnect it if the fitting does not release, making sure the prongs are correctly and evenly positioned on the release collar and fitting.
- First, make sure the pipe side prong is fully seated on the pipe and uniformly distributed over the release collar, while the fitting side of the removal tool is positioned above the fittings’ barrel.
- Pull the fitting away from the pipe by squeezing the removal tool handle until the release collar is fully compressed.
- It may be easier to dislodge the fitting by slightly turning the pipe or fitting.
- Remove the tool and reconnect it if the fitting does not release, making sure the prongs are correctly and evenly positioned on the release collar and fitting.
FAQs
A SharkBite fitting can be securely removed and reused up to two times. Do not reuse your SharkBite fitting if it has been in use on a plumbing line for longer than 1–2 months. Remove it and replace it with a fresh one. SharkBite fittings should only be used once throughout the installation process.
SharkBite fittings are made to ensure a leak-free seal. When a SharkBite fitting leaks, the first thing to check is that the pipe is attached properly to the fitting. You might be able to solve the problem by disconnecting and reconnecting the pipe.
Quick-connect and push-to-connect fittings are temporary and should only be used for that purpose. After a while, the lubricant on a SharkBite’s collet wears off, and the O-ring on either fitting may strain or wear out.
SharkBite fittings and other types of push-fit fittings, according to most expert plumbers, should only be used as an emergency, temporary fix and not for any enclosed or permanent plumbing system. However, there is a growing number of do-it-yourselfers who disagree.
To make a suitable seal, use Teflon tape with threaded SharkBite connectors. SharkBite Universal fittings (threaded or push-to-connect) should not be used on galvanized tubing.
SharkBite fittings, according to these homeowners, are just as sturdy as soldering. Some of the objections leveled with SharkBite and other push-fit fittings include: first, push-fit fittings lack the trustworthiness of soldering. Push-fit fittings have been around considerably longer than soldering.
Abrasive edges may cut the O-ring that seals off the water if the pipe is not reamed or reamed incorrectly. In fact, faulty or missing reaming is probably the most common cause of O-ring failure. Measure – make sure the pipe is fully placed into the fitting to the depth recommended in the instructions.
Sharkbite fittings are excellent, but they’re also quite pricey, so I didn’t want to risk using tubing with burrs, no matter how minor. The tool is beneficial for marking out the depth of the insertion line, but it isn’t absolutely necessary.
DISCLOSURE: This post may contain affiliate links, meaning when you click the links and make a purchase, we receive a commission.
1 comment
Comments are closed.