The maintenance light on a 2014 Toyota Camry can be reset by following these steps:
- Turn the ignition off.
- Hold down the odometer reset button.
- Turn the ignition to the on position.
- Keep the odometer reset button held down until the maintenance light goes out.
FAQS
The maintenance required light on a Toyota Camry can be reset by pressing the odometer reset button.
To reset the maintenance light on a 2014 Toyota Camry with push button start, you will need to use the owner’s manual. The procedure will vary depending on the year and model of your car.
The maintenance light on a 2015 Toyota Camry can be reset by pressing the “trip” button on the instrument panel and then holding it down for more than three seconds.
To reset the maintenance light on a 2013 Toyota Camry, you will need to use a scan tool. Connect the scan tool to the vehicle’s diagnostic connector, turn the ignition on, and reset the light.
To reset the maintenance light on a 2014 Toyota Tacoma, you will need to use a scan tool.
To reset the maintenance light on a 2014 Toyota Tacoma, you will need to use a scan tool.
The maintenance light on a 2014 Toyota Prius can be reset by following these steps:
Turn the ignition to the ON position.
Press and hold the brake pedal.
Press and release the engine start/stop button.
The maintenance light will turn off.
To reset the maintenance light on a Toyota Camry 2021, you will need to use the trip meter. First, make sure the car is turned off and the key is out of the ignition. Next, locate the trip meter and press the reset button. Hold the button down for a few seconds until the light goes out.
On a 2015, the maintenance light is reset by pressing and holding the “reset” button for about five seconds.
The oil light reset procedure on a 2014 Toyota Tundra is as follows:
Turn the ignition to the “ON” position.
Press and hold the “TRIP” button.
While holding the “TRIP” button, turn the ignition to the “OFF” position.
Release the “TRIP” button.
Turn the ignition to the “ON” position.
The oil light should be off.
The maintenance required light flashes when you start your car to indicate that it’s time for a tune-up. The light will usually stay on for a few minutes, but it’s important to take your car in for service as soon as possible. Failing to maintain your car can lead to decreased performance and even engine failure.
The maintenance light in a Toyota is turned off by resetting the oil life monitor. To do this, press and hold the “reset” button on the oil life monitor for about three seconds. The light will turn off after a few seconds.
See Also: How To Turn Off Seatbelt Alarm Toyota Highlander 2021