How To Reset Maintenance Light On Toyota Corolla

There are a few ways to turn off the maintenance required light on a Toyota. The first is to take the car to a dealership or service center and have them reset the light. The second is to use an OBDII scanner to reset the light. The third is to disconnect the car’s battery for a few minutes.

The maintenance required light on a 2010 Toyota Corolla can be reset by pressing the odometer reset button. The button is located to the left of the steering wheel, and it’s shaped like a small triangle.

There are a few ways to reset the maintenance light on a 2007 Toyota Corolla. One way is to use the keypad located on the driver’s side door. To do this, press and hold the “0” button for three seconds. Another way is to use the trip meter. To do this, press and hold the “M” button for three seconds.

There are a few ways to reset the maintenance light on a Toyota Corolla 2018. One way is to use the car’s computer system. Another way is to use a reset tool, which can be purchased online or at a car dealership.

The maintenance light on a Toyota Corolla 2021 can be reset by following these steps:

1. Turn the car off.
2. Hold down the trip meter reset button.
3. Turn the car on while still holding the button down.
4. The maintenance light should now be off.

The maintenance required light on a 2013 Toyota Corolla can be reset by following these steps:

1. Turn the ignition to the ON position.
2. Press and hold the trip meter reset button.
3. Turn the ignition to the LOCK position.
4. Release the trip meter reset button.

The reset procedure for the maintenance light on a 2009 Toyota Corolla is as follows:

1. Turn the ignition key to the “ON” position, but do not start the engine.
2. Press and hold the “TRIP” button until the “OIL LIFE REMAINING” indicator begins to blink.
3. Release the “TRIP” button and press it again.

The maintenance required light on a 2005 Toyota Corolla can be reset by turning the ignition key to the “on” position and pressing the odometer reset button. The button is located to the right of the steering wheel, and it’s circular with a small hole in the center.

To reset the maintenance light on a 2014 Toyota Corolla, you will need to use the car’s computer. First, turn on the ignition and press the “Menu” button. Then, use the arrow buttons to select “Maintenance/Tire Pressure.” Finally, press the “Enter” button and follow the on-screen instructions.