There are a few ways to reset the maintenance light on a Toyota Tacoma. One way is to use the key fob. With the key fob in your hand, press and hold the “lock” and “unlock” buttons at the same time. Another way is to use the instrument panel. With the engine off, turn the ignition switch to the “on” position and then press and hold the “trip” button. The maintenance light should then reset.
FAQs
The maintenance light on a Toyota Tacoma can be reset by following these steps:
Turn the ignition off
Press and hold the odometer reset button
Turn the ignition on
The 2017 Toyota Tacoma has a maintenance light that comes on to remind you when it’s time for an oil change or other service. To reset the light, you’ll need to access the vehicle’s computer system. There are a few ways to do this, but the most common is to use a scan tool.
To reset the maintenance light on a Toyota Tacoma 2021, you will need to use the OBDII scanner. Once you have the scanner, connect it to the truck’s port and turn the ignition on. Next, select the “Maintenance” menu and then press “Reset.” The light will turn off once the reset is complete.
The 2016 Toyota Tacoma has a maintenance light that comes on to remind the driver to have the vehicle serviced. The light can be reset by pressing and holding the “Maint. Reset” button for three seconds.
The reset procedure for the maintenance light on a 2014 Toyota Tacoma is as follows:
Turn the ignition key to the “on” position, but do not start the engine.
Press and hold the “trip” button until the maintenance light turns off.
Start the engine.
To reset the maintenance light on a 2013 Toyota Tacoma, you will need to use the Diagnostic Trouble Code (DTC) reader. The procedure for doing this is as follows:
Turn the ignition switch to the ON position.
Press and hold the odometer reset button.
Turn the ignition switch to the LOCK position.
Wait for 10 seconds.
Turn the ignition switch to the ON position.
The oil light on a 2014 Toyota Tacoma can be reset by turning the engine off and then on again.
The 2020 Toyota Tacoma has a maintenance light that can be reset by following these steps:
Turn the ignition off.
Remove the key from the ignition.
Open the driver’s side door.
Locate the odometer reset button. It is to the right of the steering wheel, and is a small, circular button.
Push the odometer reset button in and hold it for three seconds.
The oil light reset procedure on a 2012 Toyota Tacoma is as follows:
Turn the engine off.
Remove the key from the ignition.
Open the hood.
Locate the oil level sight glass.
Look through the sight glass and locate the “Reset” switch.
Push and hold the “Reset” switch for three seconds.
Close the hood.
Start the engine.
See Also: Does Toyota Own Subaru?
