There are a few ways to turn off the maintenance light on a Toyota Camry. One way is to drive the car for a certain amount of time, usually around 10,000 miles. Another way is to reset the computer by disconnecting the battery for a certain amount of time, usually around 5 minutes.
FAQs
The maintenance light in a Toyota is turned off by resetting the “maint reqd” light. This is done by pressing the odometer reset button, then holding it for two seconds.
On some Toyota models, you can disable the maintenance required message by pressing and holding the “TRIP” button until the message goes away.
To reset the maintenance light on a 2010 Toyota Camry, you will need to use a scan tool. Connect the scan tool to the vehicle’s diagnostic connector, and then turn the ignition on. Press and hold the brake pedal, and then press the reset button on the scan tool. Release the brake pedal, and then turn off the ignition.
The maintenance light on a 2010 Toyota Camry can be reset by following these steps:
1. Turn the ignition to the ON position.
2. Press and hold the odometer reset button.
3. Turn the ignition to the LOCK position.
4. Release the odometer reset button.
To turn off the maintenance required light on a Toyota Camry 2020, you will need to complete a scheduled maintenance service.
The Toyota Camry maintenance required light is turned off by resetting the car’s computer. To do this, you’ll need to find the computer’s reset button. The location of this button will vary depending on the make and model of your car, but it’s usually somewhere near the steering wheel or dashboard. Once you’ve found it, press and hold the button for a few seconds until the light goes off.
There are a few reasons why your maintenance light might be on. One possibility is that you need an oil change. Other potential causes could be a problem with your car’s air filter, coolant level, or brake pads. If you’re not sure what’s causing the light to come on, it’s best to take your car to a mechanic for diagnosis and repair.
There are a few ways to turn off the maintenance required light on a 2012 Toyota Camry. One way is to drive the car until the light turns off automatically. Another way is to reset the light by disconnecting the car’s battery for a few minutes.
There are a few ways to reset the maintenance light on a 2011 Toyota Camry. One way is to use the key fob. With the key fob in your possession, open the driver’s side door and press the “lock” button three times. The maintenance light should reset. Another way is to use the instrument panel. With the car turned off, locate the “reset” button on the instrument panel.